The ignition key must be in the key cylinder for cylinder removal.
要拆卸钥匙柱点火钥匙必须在钥匙柱中。
DOOR AJAR, IGNITION KEY ON
门半开，点火钥匙接通
Remove the ignition key (but keep it in hand).
移开点火钥匙（但将之放在手里）
To electrically start a vehicle without using an ignition key.
不用点火钥匙而用电来发动汽车。
When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off.
当连接黄色电源线时，即使点火钥匙关闭，也总是向记忆电路供电。
"After the engine starts and the ignition key is released, spring pressure returns it to the ON position."
发动机启动以后,点火钥匙回转,在弹簧的压力下,恢复到"开启"位置。
FOR INTERMITTENT 2ND GEAR OPERATION AND THEN A SUBSEQUENT RETURN TO NORMAL OPERATION WITHOUT CYCLING THE IGNITION KEY
对于间歇的第二档操作，及随后的不用旋转点火钥匙就能返回正常操作
REMOVE THE KEY FROM IGNITION SWITCOPEN LEFT FRONT DOOR.
从点火开关移走钥匙。打开左前门。
BACK JUMPER A WIRE BETWEEN KEY-IN IGNITION SWITCH SENSE & GN
在插钥匙点火开关与的之间用跳线探测。
Insert the key in the ignition lock cylinder and turn the ignition switch to the On position.
将钥匙插入点火锁柱中，旋转点火开关到开启的位置。
Keycase drew the keys from the ignition.
奇开匙把钥匙从发火装置上取了下来。
BACKPROBE A JUMPER WIRE BETWEEN THE KEY-IN IGN SWITCH SENSE CKT 6 GN
在钥匙点火开关感知器电路和地之间连接一跳线。＊
CONNECT A JUMPER WIRE BETWEEN THE KEY-IN IGNITION SW SENSE CKT & GND CKT.
在钥匙点火开关感知器电路和地之间连接一跳线。
USING AN OHMMETER MEASURE THE GROUND CIRCUIT AT KEY-IN IGN SWITCH CONN.
利用欧姆计测试在钥匙点火开关接头的接地电路。
When we turn the key in the ignition and get silence, we know we’ve got a problem.
当转动点火装置的钥匙没有听到声音时，我们知道有麻烦了。
Destroy the V2 Rocket. The Ignition key will be around nearby.
毁掉v2火箭。发射钥匙就在附近。
Your symbols are the athame, torch, scourge, key and the cauldron.
匕首、火炬、鞭子、钥匙与斧子是您的象征。
To make or grind a bit on(a key).
给（钥匙）做或磨钥匙齿