It is suggested that the vertical stiffness of the mid-axle should be lower than the end axle.
分析了铁路进一步提速对机车牵引动力的要求,从改善机车在既有线路运行时的动力学性能及曲线通过性能出发,对200km/h机车(C0-C0轴式)一系簧有关刚度进行分析计算,认为应使中间轴一系簧垂向刚度小于端轴。
The failure of 40 Cr steel end axle is analyzed by metallographic examination,chemical analysis and mechanical testing.
采用光学显微镜分析、化学成分分析和力学性能试验,对40Cr钢端轴断裂件进行分析。
New structure of shaft end fixture;
一种轴端处紧固联接的新结构
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
fan end thrust ball bearing
风扇端止推滚球轴承
axial double mechanical seal
轴向双端面机械密封
SMALLER DIAMETER OF PIVOT BEARING
轮毂轴承的较小直径端
End play in drive pinion bearings.
驱动小齿轮轴承的端隙。
vertical -spindle double ended grinding mahcine for piston ring
活塞环立轴双端面磨床
Drilling machines-Spindle noses
GB/T2815-1989钻床主轴端部
horizontal spindle double ended grinding machine for piston ring
活塞环卧轴双端面磨床
Pressure-compensated air bearings are used on both ends of the trunnion axis.
耳轴两端各用一压力补偿空气轴承。
The dates you specified for the axis values can't be used, because the maximum axis value must occur at a later date than the minimum axis value.
为坐标轴指定的日期非法。坐标轴远端的日期必须晚于近端的日期。
Either extremity of an axis through a sphere.
（轴的）两极穿过一个球体的中轴的两端中的任一端
Research on Influence of End Contact and End Restriction in Soil Tri-axial Tests;
土工三轴试验中端部接触和端部约束影响研究
A metal pivot or journal at the end of a shaft or an axle, around which a wheel or other device turns.
轮轴，枢轴在车辕或车轴某端的枢轴或轴颈，车轮或其它装置绕其旋转
Dimensions of spindle ends for manually operated electronic components
GB/T2775-1993手控电子元件的轴端尺寸
Spherical plain bearing rod ends-Boundary dimensions and tolerances
GB/T4222-1991杆端关节轴承外形尺寸和公差
Spherical plain bearing rod ends-Boundary dimensions
GB/T9161-1988杆端关节轴承外形尺寸
distance from spindle nose to central line of table
主轴端面至工作台中心线距离
Lock rings at the end of shaft with scre
GB/T891-1986螺钉紧固轴端挡圈