Framework-oil seal design and manufacture of oil die for car rear axle;
轿车后桥半轴骨架油封模具设计与制造
Finite Element Analysis of Dynamic Sealing Performance of oil seal;
油封动态密封性能的分析
ANSYS was utilized to establish the two-dimensional axisymmetric finite element model of oil seal.
利用ANSYS建立了橡胶油封的2维轴对称模型,分析了过盈量、唇口接触宽度R,弹簧劲度以及后唇角β与油封唇口压力大小及分布的关系。
Aimed at the front and back oil sealing leakage of diesel engine in Qingzhang electrical generation vehicle during operation,the leakage reason was analyzed based on the properties,structure and sealing principle of oil sealing,some improvement measures were presented.
针对青藏发电车运行中存在的柴油机曲轴前后油封渗漏油现象,基于油封性能、结构及密封原理,分析油封渗漏油的原因并提出了预防及改进的措施。
1 Steelmaking Plant is analyzed and the existing problems found out,and the original threaded oil seals replaced with 323 I type magnetic oil seals,therefore the oil leaking problems are thoroughly solved.
对能源动力公司一炼钢转炉煤气鼓风机的油封结构进行了分析 ,找出了存在的问题 ,并将原螺纹密封改造为 32 3I型磁力油封 ,从而彻底解决了漏油问题 ,既降低了费用消耗 ,延长了轴承寿命 ,又消除了环境污染和安全隐患。
Front Oil Seal Installer 6635
前油封安装器6635
spindle inner oil seal
(平衡器) 轴内油封
Install new front crankshaft oil seal.
安装新的前曲轴油封。
oil-sealed jar safety joint
油封式震击器安全接头
Remove and discard the front crankshaft oil seal.
拆下并抛弃曲轴前油封。
Oil pan timing case cover seal
油底壳与正时齿轮盖油封
Study of Sealing Performance and Wear Mechanism of Oil Seal Used in Engine
发动机油封的密封性能及磨损机理研究
Research on Thermal Spraying for Flow Oil-seal Ring and Its Application
浮动油封密封环热喷涂工艺的应用研究
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
Analysis and Solution of Oil Leakage of Driving Axle Boss Oil Seal for Autombile
汽车驱动桥轮毂油封漏油问题的分析与解决
preservative lubricating oil
封存[防锈]润滑油
oil pressure test for tightness
油密试验油压密封试验
DSS tubing joint
双密封专用油管接头
hook wall pumping packer
抽油井悬挂式封隔器
oil sealed rotary vacuum pump
油密封式旋转真空泵
Piston rings not sealing (oil being consumed by the engine).
活塞环没密封（引擎用油）。
overshot tubing seal divider
打捞筒油管密封分压器
oiled sealed waterless gasholder
上油密封干式煤气柜