Experimental Research on the Technology for Installation and Replacing Simple Supported-Continuous Girder Bridge Bearing
简支转连续梁桥支座安装与更换技术试验研究
Installation Technologies of Preburied Prestressed Anchor Bolts of Wide Diameter Pin Roll Hinge Supports
预埋预应力锚栓的大直径销轴铰支座安装技术
Existing Problems and Solutions of Plate Rubber Support Installation
桥梁板式橡胶支座安装存在的问题及解决方案
The Installation Technology of Support Saddle over the Non-navigable Span of Jintang Bridge
金塘大桥非通航孔桥支座安装施工技术
Installation Technology for Hyperboloid Spheroidal Antivibration Supports in Railway Bridge
一种新型铁路桥梁双曲面球型减隔震支座安装技术
"Controllers may be supplied with painted steel floor mounting legs. For base mounting or stainless steel mounting legs, consult the Factory."
可提供配置涂漆钢地面安装支架的控制装置。如果需要底座安装或不锈钢安装支架,请工厂联系。
Supervision control point of laminated rubber bearing
板式橡胶支座施工安装的监理控制要点
accessory drive pad
附件传动装置安装座
Install the seatback in the vehicle.
在车辆里安装座椅背。
a support pedestal for mounting of the complete pump /motor assembly shall be provided and shall be constructed of fabricated steel.
应该提供用于安装泵/电机总装的支撑基座,其结构材料应该采用预制钢。
Each boiler is equipped with2 safety valve( over2 pcs) for relief the pressure due to its over pressure which will keep its safety.
每座锅炉皆装置两支以上之安全阀，超压时得以释放压力，以确保安全。
seat with integral seat belt anchorages
设有原装安全带固定装置的座位
Install the seat/shoulder belt anchor bolt.
安装座椅/安全肩带系紧螺栓。
Slide the memory seat module off of the two mounting bracket slide tabs far enough to access and unplug the wire harness connectors.
将存储座位模组滑离两个安装支架滑式舌片，直至足以够着并拔下线束接头。
Install thrust support assembly.
安装侧推支撑总成。
Install the exhaust pipe support.
安装排气管支撑物。
Install ABS sensor wires into brackets.
安装ABS感知器线到支架。
Install the rearview mirror on the bracket.
在支架上安装后视镜。