Calculation of contact pressure on TM and VAMACE premium connection casing couplings;
TM和VAMACE特殊螺纹套管接箍接触压力计算
The effect of articular step-off and neniscectomy on joint alignment and contact pressures for fractures of the lateral tibial plateau;
胫骨外侧髁骨折塌陷对关节轴线及接触压力的影响
Single chip microcomputer-based inspection of catenaries-pantograph contact pressure;
基于单片机的弓网接触压力检测
Research on contacting pressure in ball-spinning;
滚珠旋压工艺中成形区接触压力的分析计算
A pin-on-disk test rig was used to investigate the influence of sliding speed and contacting pressure on the friction and wear behavior of 45CrNi pair under dry sliding condition.
利用销盘摩擦磨损试验机,考察了干滑动摩擦条件下滑动速度、接触压力对45CrNi摩擦副摩擦磨损性能的影响。
The progressive cavity pump(PCP) distortions,forces and contacting instance of different pressure with the finite element analysis method are analyzed,the PCP two-dimension finite element model is constituted,the stress distributing correspond to the PCP stator rubber and the contacting pressure of the stator and rotor are obtained in this paper.
用有限元方法对螺杆泵在不同压力作用下的变形、受力及接触情况进行了分析研究,建立了螺杆泵的二维有限元模型,得出了在相应情况下螺杆泵定子橡胶的应力分布和螺杆泵定子与转子的接触压力。
FEM fitting of contact flattening equation of working rolls in cold strip steel rolling;
有限元法修正冷轧带钢工作辊接触压扁公式
Pushing of the shaft for the contact pressure profile and the influence of the relative position of the hydraulically assembled shaft and sleeve are stressed and considered in the calculations.
介绍了用有限元法计算盘磨机轴的接触压强，所得数值及分布规律是可靠的；并讨论了轴压入量与直径过盈量及配合长度的关系。
An uneven contact pressure between the wire and pad is indicated,which explains the welding formation in experi.
本文采用弹塑性、大变形的非线性有限元方法,模拟了超声波线焊的过程,分析了接触界面的接触压强分布,发现不均匀的接触压强分布是导致这种焊点形态的主要原因。
The distribution law of contact pressure between flange and gasket is presented.
采用接触有限元方法,计算了螺栓、法兰和垫片三者之间的相互作用,给出了法兰和垫片间接触压强的分布规律,指出了考虑法兰接头密封时管道内压是一个不可忽略的计算因素,验证了螺栓之间的区域为密封的薄弱环节。
Methods Hertzian contact technique with WC spheres was used to investigate the response of feldspathic dental porcelain to cyclic fatigue.
目的比较两种最大载荷值下牙科脆性陶瓷赫兹触压循环疲劳损伤模式。