This machine applies to cutting the adobe strips extruded from plasticity or half-plasticity and use with single and double jaw brick-make machine.
本机适用于切割硬塑或半硬塑挤出的坯条，与单、双泥条挤出切坯配套使用。
The brick cutter including swallow-tailed slide is substituted for bar slide.
该机采用燕尾式作滑道结构代替滑杆式结构的新一代切坯机。
The Approach About the Cutting Torch Cuts Slab Regularly after Ethernet Has Trouble
H1网故障切割机正常切割板坯的研究
cutting machine for unfired ceramic brick or tile
陶瓷砖块或瓷砖生坯切割机
Research on Algorithms for Open Cutting and Mesh Generation for Sheet Metals;
工艺切口与坯料网格剖分算法的研究
Practice of Electrical Transformation of Flame-cutting Machine for Slab Continuous Casting
板坯连铸火焰切割机的电气改造实践
Reasonable Control the Upper Crop End and Lower Crop End Weights,and Improve the Utilization Rate of Crankshaft Blank of Electroslag Remelting Ingot
合理控制切头切尾量,提高电渣钢曲轴坯成材率
Study of the Automatic Adjusting Technic of Flame Cutting Slab Cut Length System in Slab CCM
板坯连铸机二次火焰切割铸坯定尺自动无级调节技术的研究
Finite element analysis of a steel billet cut-off machine body
QA95-630型钢坯剪切机焊接机身的有限元分析
Research on Cutting Length Optimization Model for Continuous Casting Slab
板坯连铸过程切割优化控制模型的研究
Elevated Temperature Ductility of Cast Bloom of Non-Quenched and Tempered Free Cutting Steel 38MnVS
非调质易切削钢38MnVS连铸坯的高温延塑性
Definition of protecting cover blank demension and design principle of cropping froming block
护罩毛坯尺寸的确定及切料成形模的设计原理
Application of Limited Weight Cutting Technology in Billet Limited Weight System
定重切割技术在钢坯定重系统中的应用
Turning operations are required to make many different cylindrical shapes, such as axes, gear Blanks, pulleys, and threaded shafts.
车削用来切削出不同的圆柱形,如转轴、齿轮毛坯、滑轮、螺纹轴等。
Olivia runs a lathe which cuts semifinished product of metal by inches.
奥利维亚开动一台车床，车床一点一点地切削着金属毛坯。
Detection of Billet and Shear Chin Position of Flying Shear System and Control of Fixed Length Crop
飞剪系统中钢坯、剪刃位置的检测及定长切头控制
Cutting length optimization system of process computer in No 2 slab CCM of Panzhihua Iron and Steel Co
攀钢2号板坯连铸过程计算机切割长度优化系统
Made of shaping Polytetrafluoethylene Resin into blank by moulding in ordinary temperature, through high heat sintering, then ratary cut.
用聚四氟乙烯烧树脂在常温下用模压法制成坯料，经高温烧结后旋切而成。